Are you wondering about the cost of hydro-jetting a drain ? Then keep reading the article.
There is water backing up into other drains and toilets that don’t flush properly. It’s likely that a clogged main sewer line is the source of the plumbing issues in your home if this sounds like what’s happening.
You might think that you need to use a drain snake to remove the clog. However, hydro jetting is an approach that will produce better outcomes in this case.
Hydro jetting involves shooting water at high pressure through a pipe using a flexible hose. A plumber will inspect the sewage line to ascertain the severity of the damage before beginning this form of repair.
The average pressure of these systems is 35,000 psi, which is more than adequate to clear even the most entrenched obstructions. While hydro jetting is more expensive than some other options, it can save money in the long run if you need to clear up your main sewer line.
also read – WHY YOU NEED A NATURAL MIST FOR FACE IN YOUR LIFE
When use Hydro jetting?
At what point should you consult a plumber for advice on hydro jetting? If you have tree roots in your pipes, many drains and plumbing fixtures are backing up, your pipes are clogged with grease and hair, or you need to clean your pipes out before they are relined, hydro jetting may be the solution for you. The use of this method will also forestall the accumulation of dangerous trash.
Although chemical agents to dissolve a blockage or just snaking your main sewer line may be less expensive, they won’t be as effective as hydro jetting in situations where hydro jetting is required.
These are remedies for minor clogs that won’t require major surgery to remove. In extreme cases, a force-ball plunger or other inexpensive solutions won’t be able to clear the clog.
It all comes down to the location and severity of the obstruction to determine whether or not a drain snake would help. A snake won’t help you if you have a particularly stubborn blockage or if the obstruction is located deeper in the drain system.
A person’s eyes, skin, and pipe lining are all vulnerable to damage from toxic chemicals. Because of their inability to treat all obstructions, they have limited utility. It’s possible to make matters worse if you apply them to the incorrect kind of problem.
Cost of hydro jetting a drain
The typical cost for a homeowner to have a stubborn clog removed from their sewage line is between $100 and $900.
Hydro jetting a clogged sewer pipe typically costs between $350 and $600. The price of hydro jetting could be $1,000 or more, depending on the severity of the issue.
Hydro jetting costs more than snaking your sewer line, but it eliminates obstructions for good by clearing out the pipe’s inside rather than just punching a hole in it.
Cost to repair a sewer line
Unfortunately, hydro jetting isn’t always the best solution. When pipes are broken or corroded beyond repair, this can occur. Hydro jetting can exacerbate the issue in these circumstances due to the pressure that is applied, which might cause further damage to the pipe.
If this is the case, you should have your main sewer line checked or replaced. Trenchless pipe repair, if it is possible for your plumbing, will set you back about $160 per foot.
Expenses incurred to fix the foundations, roadways, and pathways that are destroyed during a dig-and-replace job can add up quickly. Adding the price of laying sod onto your lawn is something to think about if you have one.
Sewer main repairs typically run between $1,000 and $7,500. Hydro jetting’s ability to blast the debris out of the pipes that attract and collect it is a major benefit in preventing the clog from reoccurring.